FAQ
FAQ
  • How to add smart gateway device?  

    Preparation before configuration:


      1) Power on the gateway and plug it into the router, press and hold the reset button on the gateway for a few seconds, wait for all its indicators to go out and then stay on

      2) Power on the camera, press and hold the reset button for a few seconds, and then hear the camera voice prompts " Reset completed". After the camera kit is started, it will automatically connect to the gateway and prompt "Network connected"


    Configuration steps:


      1) Open the APP, click the button at the top right corner of the device list, scan the QR code on the gateway with your mobile phone, and continue to operate according to the system prompts. If the QR code is damaged, click [Can't find the QR code on the device], select [Gateway] and follow the system prompts to continue

      2) After the system prompts "Bind successfully", click Start Adding Camera to complete the connection

      3) If you want to add a non-kit camera, after turning on WLAN on your phone, select the corresponding gateway under the [Gateway] group in the APP device list, click Add Camera, select the gateway network, and follow the system prompts to complete the connection


    Gateway indicator light status:


      1) Power indicator light( Red )

           Off: device powered off

           Steady on: system startup completed

           Flashing: firmware updating


      2) Network indicator light( Green )

           Off: not connected to the Internet

           Steady on: connected to the Internet

           Flashing: poor network connection


      3) AP hotspot indicator light( Blue )

           Off: AP hotspot disabled

           Steady on: AP hotspot enabled

  • How to connect the camera to the router without QR code?e  

      · Power on the camera and observe its status, press and hold the reset button for a few seconds, and then hear the camera prompt "Reset completed". Open the APP, click the "+" button in the upper right corner of the device list to add the device, and continue to operate according to the system prompts. If there is no QR code or the QR code is damaged, click [Can't find the QR code on the device]


      · Follow the camera's voice prompts to select the network configuration method, and continue the operation according to the system prompt


        1. If the voice prompts "Please scan the QR code on the camera", select [QR code connection]

        2. If the voice prompts "Access point ready", select [AP hotspot connection]

        3. If the voice prompts "Bluetooth is ready", select [Bluetooth connection]

        4. If the voice prompts "WiFi connecting" does not respond, please restore the camera to factory default settings and reconnect according to the above steps

        5. If the voice prompts "Network connected" after power on, select [LAN connection] to search for the device and add it


  • During the configuration process, the device has connected, but the APP doesn't prompt "Completed"?  

      · The device has been successfully connected to the Internet, just add the connected device to the APP

      1) Click the "+" button in the upper right corner of the device list, click [Enter manually]

      2) Fill in device ID or scan the QR code on device as prompted by the system, then click [Confirm]

      3) APP prompts "Added successfully"